PS TMB PS 079, Owner’S And Fitting Manual

Page: 12 / 16

12
KIA Ce e´d S W:
Dismount t he bottom p lastic p art from t he re ar b umper (s ee fi gure 5 ).
According to figure 6 c ut off from this part four portions marked by gray color. Mount back
these portions on the rear bumper (see figure 7).
5. Remove (if necessary) the plastic protection from close of the fixing holes and clean the fine
thread in these holes.
6. Loosely fix the beam assembly with six bolts M10 x 1,25 x 35 ( 6), washers (7) and spacer
washers (8) – see figure 1. Draw the structure backwards from the car and
tighten the bolts in
turns on both sides by the torque 40 Nm .
7. Go o n w ith e lectrical i nstallation o f to wing d evice o n th e c ar ( see a ssembly in structions
enclosed to w iring k it). Screw t he s ocket hol der w ith m ounting of t he t ow a rm. After
completing th e electric installation, mount back all dismantled parts and tighten all r elative
joints by prescribed torques
8. Fix the towing arm (2) between the holders by means of two bolts M12x65 (4) and nuts M12
(5). Mount the socket holder (3) and safety lug (9) according to figure 1
and tighten the bolts
by the torque 80 Nm.
9. On the rear bumper over the tow bar there is the place where you put the self-adhesive sticker
“75 kg” – (before sticking you must clean and degrease that place).
10. Cover the ball pivot by its protective lid (10).
For assembling of the towing device the workshop handbook is needed, therefore it can be
done only by accredited service.
Electrical installation is not delivery component and it must be ordered separately.
Advise for the user
- After d riving the f irst approx. 5 00 k m w ith a trailer i t i s n ecessary to ch eck the b olts
fixing t he c rossbeam t o t he unde rbody a nd t he bo lts f ixing t he t ow ba r by a t ongue
wrench at prescribed torques! W e recommend to have this check done at your nearest
authorized service station.
- Grease the ball pivot as need be by a suitable lubricant.
- Check the function of all the lights on the trailer after coupling and plugging in.
- Any adjustments and modifications of the towing equipment are not allowed.
- Follow all instructions for the use published in this leaflet.
- The producer is not accountable for any damage resulting from incorrect installation of
the equipment, overloading or any other mechanical impairment.
- It is not allowed to use the equipment when it is damaged or incomplete.
- The pivot ball must be protected by its cover when nou trailer is coupled !
- The tow bar (in case it is dismounted) should be placed in the boot of the car in the way
not to endanger the passengers or damage the interior of the boot. The ball pivot must
have its cap on.