5
Half-Rack Assembly Instructions
1. Assemble the sides and attach the feet. Lay the components on the floor, making sure the
logos on the uprights will face out once fully assembled (Figures 1 & 2).
2. When attaching the crossmembers, be sure to orient them correctly (see Min. and Max. in
Figures 4a & 4b). The crossmembers need to be assembled this way for future accessories
to fit properly.
3. Repeat on other side.
4. Secure all hardware, but do not fully tighten.
Logo on back side
of rear uprights.
5
1. First make sure all your components and hardware are accounted for, according to the Parts List on
page 3. Make sure you look under the correct configuration.
2. Start with the side portions of the rack, making sure the upright on the logo is on the front side of the
front upright, and on the back side of the rear upright. It may be easiest to lay the components down on
the floor while assembling. (see figures below)
3. Make sure the crossmembers are oriented as shown in Figures 4a and 4b. The tubes are offset from
the end plates and need to be placed correctly in order for future accessories to fit properly.
4. Once you’ve completed one side of the framing, continue to do the same for the other side. BE CARE-
FUL not to overtighten any of the bolts as this could result in deformed uprights and make it difficult to
further assemble any additional components.
[email protected] 701-566-0452
Start of Half-Rack Assembly
Figure 1
Front
Rear
Min.
Max.
Figure 4b
7
10
Figure 3
7
5
3
1
10
Figure 2
Logo on front side
of front uprights.
10
3
1
8
9
8
9
Min.
Max.
Figure 4a
