7
Half-Rack Assembly Instructions
1. Attach rear crossmember. As with the side crossmembers, be sure to orient the rear
crossmember correctly so it’s at the right height and for future accessories to fit properly
(Figure 8).
2. Attach the spreader plate. Be sure the spreader plate is flat to the floor before attaching.
3. Anchor rack to the floor and fully tighten all hardware.
Note: Do not overtighten any of the bolts as this could result in deformed uprights.
7
1. With the pull-up bar attached to both sides of the rack, it should be able to stand on it’s own. Now you
attach the rear top crossmember and the spreader plate down at the bottom.
2. Make sure the rear crossmember is oriented as shown in Figure 8. The tube is offset from the end
plates and needs to be placed correctly in order for the crossmember to be at the correct height, and for
future accessories to fit properly.
3. Make sure the spreader plate is flat to the floor and tighten hardware on both ends.
4. Now that all components are assembled, make sure all the hardware is tight, but BE CAREFUL not to
overtighten as this could result in deformed uprights.
5. Rack can now be anchored to the floor if desired.
[email protected] 701-566-0452
Half-Rack Final Assembly
Figure 7
Figure 8
10
8
Min.
Max.
2
8
9
10
9
Figure 9
10
6
9
8
9
