12 FAQ ‐ common issues when assembling the printer kit
12.1 Nozzle/print surface gap is greater in the middle than at the
corners
The reason of this issue isn’t the bent printer surface or bed but a distorted Yaxis. We
suggest to remove the whole Yaxis out of the
printer
. Follow these steps:
● Align the Yaxis so that each Ycorner is sitting on the table none should be off the
table.
● Align the tightening of each Yaxis threaded rod so that each Ycorner is
perpendicular (facing upright) to the table surface.
● Align the tightening of each Yaxis threaded rod so that each M8 threaded rod is at a
right angle to the M10 threaded rods the Yaxis must form a perfect rectangle when
viewed from above (
pict
. 30).
Pict. 30 Right angle between Yaxis and M8 / M10 rods
40