6.3.10.2 Check probe height
(kit only)
If the first layer seems inconsistent between multiple prints, the probe might be
too high. Lower it slightly and try again
Calibration XYZ
. Keep in mind, the probe
must be always higher than the nozzle tip, otherwise it will catch on prints.
Pic. 11 Probe response diagram.
6.3.11 Securing of the probe (kit only)
After couple of prints ideally secure the bottom nut on the probe with a drop of
Loctite 243
(Blue Threadlocker) to prevent loosening over time.
Pict. 12 Secure the bottom nut on the probe with a drop of Loctite 243
Now you are done!
Summary of Contents for Original Prusa i3 MK2
Page 1: ......
