page 57
cos105000-2016-00 en
Option Description
Comment / Display
OP11
Scaling of the profiles in profile mode (not for
test mode)
shows: Scaling possibilities
0: No scaling (standard)
1: Scaling 1...6, which is shown in the profile mode on the INDEX
display, refers to all parameters together (speed, elevation, time)
2: Scaling 1...6 refers to each parameter individually (speed, elevation,
time)
OP12 Unit for display of speed
indicates: Unit of speed
... without decimal place:
3 = m/min
... with one decimal place:
0 = km/h 1 = m/s 2 = mph 23 = m/min
... with two decimal places:
20 = km/h 21 = m/s 22 = mph
km/h, m/s, mph or m/min flashes
OP13 Unit for display of distance
indicates: Unit of distance
0 = km 1 = miles 2 = m
m, km, or miles flashes
OP14 Unit for angle of elevation
indicates: Unit of elevation
0 = % (per cent) 1 = ° (degree)
% or ° flashes
OP15 Subject's body weight
(default value)
indicates: 10 ... 250 (estimated weight)
weight flashes
The personal body weight is necessary for a more correct calculation
(estimation) of power and energy consumption.
OP16 Request for body weight
before manual or automatic start
0 = OFF. Request for body weight before starting a program is not
required. Calculation of energy consumption and power is based on
the body weight entered in option no. 15.
1 = ON. Input of body weight before starting a program is required.
Calculation of energy consumption and power is based on the entered
body weight.
OP17 Unit for energy consumption
JOUL = kJoule is the unit of energy consumption
CALO = kcal is the unit of energy consumption
OP18 Maximum speed in cardio mode (default value)
(this option is only available for treadmill-
ergometers, not for ladder-ergometers)
reports: 0.0 ... max
for the default value for maximum speed in the cardio mode.
adjusted unit flashes,
max. flashes
The value of max. speed in cardio mode can be changed online by
pressing
OP19 Setting of sender for POLAR W.I.N.D. system
0000 0000 = all senders are accepted (can also be set with UP and
DOWN)
xxxx xxxx = only specific sender with special ID is accepted, must
be set with and
9999 9999 = next sender will be accepted, saved and filtered
(can also be set with UP and DOWN)
(further settings in user OP23 and administrator OP16 are necessary)
