Proteus PEC-4650, Owner'S Manual

Page: 6 / 8

OPERATING INFORMATION OF EXERCISE METER
SUMMARY :
THIS SYSTEM IS DESIGNED FOR PROGRAMMABLE MAGNETIC BIKE. THERE ARE 3 PARTS
TO THIS SYSTEM, THE MONITOR, MOTOR & CONTROLLER AND MAGNETIC BRAKING
SYSTEM.
GETTING STARTED :
1. MONITOR CONNECTIONS :
PLUG THE 10-PIN CONNECTOR ( PROTRUDING FROM THE TUBE ) INTO THE RECEPTOR ON
THE BACK OF THE MONITOR
SECURE THE MONITOR TO THE MOUNTING PLATE. BE SURE THAT THE MONITOR CABLE IS
NOT PINCHED.
REFER TO YOUR ASSEMBLY GUIDE FOR MORE INFORMATION ON INSTALLING YOUR
MONITOR.
2. POWER UP :
PLUG THE POWER CABLE INTO THE JACK OF THE MOTOR & CONTROLLER.
PLUG THE POWER PACK INTO A WALL OUTLET
AFTER POWER UP, ALL LED LIGHTS WILL LIGHT UP FOR 0.5 SECONDS & CPU WILL RESET
THE RESISTANCE INTO LEVEL 1AND THEN THE SYSTEM GO INTO THE INITIAL MODE. ( THE
8 PROGRAM INDICATION LIGHTS WILL BE FLASHING )
REMARK :
1. IF THE CONNECTION CABLES WERE INSTALLED INCORRECTLY, THE SPEED FUNCTION
WON'T ACTION AND MOTOR WON'T MOVE
2. WHEN STOP EXERCISING, PLEASE REMEMBER TO UNPLUG THE POWER PACK.
BUTTONS AND DEFINITIONS :
START/STOP :
A. USE THIS BUTTON TO START OR STOP TRACKING YOUR WORKOUT
B. HOLDING START/STOP FOR 2 SECONDS WILL RESET THE CURRENT PROGRAM & VALUES,
THEN ENTER INITIAL MODE.
SCAN:
USE THIS BUTTON WHILE EXERCISING TO SEQUENTIALLY DISPLAY EACH FUNCTION(TIME,
SPEED, DISTANCE, CALORIE & HEART RATE) FOR 5 SECONDS. PRESSING THE SCAN
BUTTON AGAIN WHILE EXERCISING WILL STOP SCANNING THROUGH EACH FUNCTION AND
WILL DISPLAY THE CURRENT FUNCTION.
/ :
A. DURING INITIAL MODE, USE / BUTTONS TO CHOOSE YOUR DESIROUS PROFILE OR
INCREASE/DECREASE PROGRAMMABLE SETTINGS (TIME, AGE & HEART RATE). HOLDING
/ FOR 1.5 SECONDS WILL CHANGE THE SETTINGS FASTER.
B. DURING EXERCISE YOU CAN USE / BUTTONS TO ADJUST THE RESISTANCE SETTING
- 5 -