OK!
NO!
Figure 12. Connecting fall protection system
1. General information
Anchor point AT150 is an anchor device class A conforming to EN 795 and is designed for protection of one person. Anchor point AT150 may be used
only as personal protective equipment which protects a user against a fall from a height, and cannot be used for lifting loads. The device is made of
aluminium alloy using pressure casting technique. In accordance with EN 795:2012 type A strength of this point is min. 12 kN in any direction. The
device is designed for protection of one person.
The maximum load that could be transmitted in service from the device to the static construction - 9 kN. This is the actual force which the anchor
point transfers onto the structure to which it is attached when a fall occurs.
If the device is used as a part of a fall arrest system, the user must be equipped with an element limiting maximum dynamic forces applied on user
while arresting a fall to max. 6 kN.
2. Overall dimensions of anchor point AT150
See fig. 2
3. Time of usage
Maximum time of usage of correctly operating devices is unlimited.
The device must be withdrawn from use immediately and destroyed if it has been used to arrest a fall or there are any doubts concerning its
function.
NOTE: Maximum time of use of the device depends on intensity and environment of use. If the device is used in heavy conditions, being exposed to
frequent contact with water, sharp edges, corrosive substances, extreme of temperatures, it may be necessary to withdraw the device after only one
use.
4. Periodic inspections
At least once a year, after every 12 months of use, it is necessary to carry out periodic detailed inspection of the device.
Periodic inspection shall be carried out by service point authorized by the Manufacturer located at the following address:
PROTEKT Grzegorz
Ł
aszkiewicz
u
l. Starorudzka 9
93-403
Ł
ód
ź
or a competent person with adequate skills, trained in performing inspections of such equipment.
A trained person is a person who, based on own specialized education and adequate experience, has sufficient knowledge within installed protective
and rescue equipment, and is familiarized with applicable OHS regulations, guidelines and generally acknowledged technical rules to such extent
that is able to assess safety of use and correct application of protections.
After 5 years of use, it is recommended that periodic inspections are carried out by the manufacturer of the equipment or an entity authorised by
the manufacturer to carry out such inspections.
Before each use of the system check whether date of the next inspection is not expired. Do not use the device after this date. Before each use of the
system visually check the system for its integrity and technical condition and whether steel cable is tensioned.
If any defect or lack of integrity is found, do not use the point. If any doubts arise as for the use of the equipment, please contac. t the manufacturer
and never repair the equipment on your own!
A system which has been used to arrest a fall must be withdrawn from use immediately!
The system which has been used to arrest a fall may be admitted for use again after a detailed inspection is carried out by the manufacturer or an
authorised service point.
2/5
READ AND UNDERSTAND INSTRUCTION MANUAL
BEFORE USING THE EQUIPMENT
