protech PC-550, User Manual, Page: 95 / 106

Appendix C Trouble Shooting
Page: C-3
PC-550 USER
′
S MANUAL
DISKETTE DRIVES OR TYPES MISMATCH ERROR :
When the diskette drive type is different from CMOS, please run setup or
configure the drive again.
ERROR ENCOUNTERED INITIALIZING HARD DRIVE :
When you can‘t initialize the hard drive. Assure the adapter is installed
correctly and all cables are correctly and firmly attached. Also be sure the
correct hard drive type is selected in Setup.
ERROR INITIALIZING HARD DISK CONTROLLER :
When this error occurs. Be sure the cord is exactly installed in the bus. Make
sure the correct hard drive type is selected in Setup. Also check whether all of
the jumpers are set correctly in the hard drive.
FLOPPY DISK CONTROLLER ERROR OR
NO CONTROLLER PRESENT :
When you cannot find or initialize the floppy drive controller, please check the
controller whether in proper Setup. If there are no floppy drive installed,
Ensure the Diskette Drive selection in Setup is set to NONE.
KEYBOARD ERROR OR NO KEYBOARD PRESENT
:
When this situation happens, please check keyboard attachment and no keys
being pressed during the boot. If you are purposely configuring the system
without a keyboard, set the error halt condition in Setup to HALT ON ALL,
BUT KEYBOARD. This will cause the BIOS to ignore the missing keyboard
and continue the boot.
MEMORY ADDRESS ERROR :
When the memory address indicates error. You can use this location along
with the memory map for your system to find and replace the bad memory
chips.
MEMORY SIZE HAS CHANGED :
Memory has been added or removed since the last boot. In EISA mode use
Configuration Utility to re-configure the memory configuration. In ISA mode
enter Setup and enter the new memory size in the memory fields.