protech PC-550, User Manual, Page: 50 / 106

Chapter 3 Software Configuration
Page:3-4
PC-550 USER
′
S MANUAL
(4). In the CHANGE DISPLAY window, click on Have Disk.
Follow the instructions appearing on the screen until you
complete the whole installation.
(5). Once installation is completed, the system must be shut down
and restarted for the new drivers to take effect.
4. Install VGA driver to OS/2 Warp Operation System
(1) Preliminary Steps:
(i) OS/2 DOS Support must be installed.
(ii) If you previously installed SVGA support, you must reset the
system to VGA mode. VGA is the default video mode enable
when OS/2 is to be installed.
(iii) To restore VGA mode, Use SELECTIVE INSTALL and
select VGA for PRIMARY DISPLAY. For more information
on this procedure, see the section on Changing Display
Adapter Support in the OS/2 User’s Guide.
(2) Start Driver installation
(i) Open an OS/2 full screen or windowed session.
(ii) Place into Drive A/B the Utility Disk, which contains the
65550 Display Driver.
(iii) At the OS/2 command prompt , type the following commands
to copy the files to the OS/2 drive:
Type A: and press ENTER to make this the default drive.
Type Setup A: C: and press ENTER
"
When the setup Program is completed, you will need to
perform a shut down and then restart the system in order for
changes to take effect.
(iv) After restarting the system, first open the OS/2 System folder.
(v) Then open the System Setup folder.
(vi) Open the Display Driver Install Object.
(vii) When the Display Driver Install window appears, select
PRIMARY DISPLAY, and click OK.
(viii) When the Primary Display Driver List window appears,
select “Chips and Technologies 65550” from the list of
Adapter types, then select OK to install the video driver.