Installer Guide
17
Wireless Remote To Use
(setup step 48)
-
Specifies which single wireless remote sensor
is to be used for control. This step only appears when prior step setting is Wireless
Remote.
Fahrenheit or Celsius
(Setup Step 65) - This feature allows the thermostat to display
temperature in Fahrenheit or Celsius.
NOTE: If a remote sensor is being used, the degree icon on the large room temperature
display will blink.
Humidity Control (Setup Steps 49-55, 80-82)
Humidity Only With Heat
(Setup Step 49) - When this step is set to ON, Humidity will not
run without a demand for Heat.
Fan with Humidity Demand
(Setup Step 50) - Specifies if the fan should be turned on
with a demand for Humidity. (This step will only appear if step 47 is set to OFF.)
Fan with Dehumidify Demand
(Set up Step 51) - Specifies if the fan should be turned on
with a demand for Dehumidify. (This step will only appear if step 50 is set to OFF.)
Humidity Setpoints
(Setup Step 52) - Specifies whether the Humidity setpoint should
be entered by the user (MANUAL) or determined automatically by outdoor temperature
(AUTO). An outdoor temperature sensor is required for the AUTO setting. If the outdoor
temperature sensor stops reading while this step is set to AUTO, the Humidity setpoint will
revert automatically to a setting of 15 percent.
Cool To Dehumidify
(Setup Step 53) - Specifies if the cooling equipment is allowed to
turn on exclusively to lower room humidity. (If set to OFF the following two steps will
not appear.)
Max Dehum Overcool
(Setup Step 54) - Specifies how many degrees below the Cool
setpoint the air conditioning will run to satisfy a Cool to Dehumidify demand during
occupied periods. (0˚ - 20˚)
Reheat Operation With Cool To Dehumidify
(Setup Step 55) - Specifies if electric strip
heat is allowed to turn on during a Cool to Dehumidify demand to help maintain desired
room temperature. This step is not available if Electric Heat is not present.
Humidity Output Polarity
(Setup Step 80)
Humidity Output Normally Open
- means no voltage is sent to the HUM output
when there is no demand for humidity.
PSP4273_Installer man.indd 17
PSP4273_Installer man.indd 17
6/9/21 11:23 AM
6/9/21 11:23 AM