CT-3460 TW
Installation Guide
P.7
on this wire after remote-start shutdown.
5
WHITE / GREEN
(–) Disarm
Max 500 mA 1-sec. ground pulse when the Doors are unlocked by
remote control. Connect to the OEM Disarm wire of the vehicle.
Note:
The system will also give a disarm pulse on this wire before
remote starts.
6
BLUE / WHITE
(+) Door pin
input
This input should be used in vehicles that use a
positive-switching
Dome Light circuit. Connect to a Dome Light wire t12 V with a
Door open.
CAUTION!
You can only use a negative or a positive connection. In
other words, only the
NEGATIVE DOOR INPUT
or the
POSITIVE
DOOR INPUT
wire is connected. It is essential that the Module be
connected in such a way as to allow
each
one of the Doors
to turn off
Ready Mode:
the driver-side Door Pin does not constitute by itself a
sufficient connection.
7
WHITE /
ORANGE
(–) Starter Kill
(armed output)
The unit is equipped with a selectable
passive-
or
active-arming
Starter Kill
circuit that will immobilize the vehicle when the system is
armed. This wire will provide a constant 500-mA negative output when
the system is armed
(locked by remote) or if remote started. This wire
should be connected to a Single Pole Double-Throw Relay (This wire
will connect to pin 85, on the Relay, and pin 86 will be connected to the
Ignition wire).
A second benefit of the Starter Kill is the Anti-Grind feature. When the
vehicle has been remote started the Anti-Grind prevents the starter
motor from re-engaging when the ignition key is inserted in the Ignition
switch
and accidentally turned to the
CRANK
position (The Starter Kill
output becomes active during remote starts).
8
ORANGE
(–) PARKING
BRAKE INPUT
Connect to the
negative
Parking brake Indicator Light wire of the
vehicle. This wire is found at the parking brake lever itself.
Note:
The wire should test ground
when the Parking brake is engaged.
9
PURPLE
(–) External
Trigger input
The External Trigger wire can be used for remote-starting the vehicle
with an external device. When the vehicle is running, triggering this
input will activate Idle Mode. The External Trigger wire can also be
used to operate as a negative trigger with the Trunk pin-switch, the Key
Sense wire or the Door pin-switch:
•
Option 1
Connects to (-) Negative Trunk pin.
When this wire is
programmed for trunk pin, pressing
TRUNK
will activate a 1-second
disarm output. If ground (-) is detected on the trunk pin (the Trunk
has been opened), an
ARM
pulse will be sent 5 seconds after the
Trunk is closes. An
arm
pulse will be sent 4 seconds after the
TRUNK
button is pressed if the Trunk pin state is unchanged (The
Trunk was unopened). Disarm is sent only if the system was
previously locked and armed.
If secure lock is enabled, unlock
pulse(s) will be sent with disarm, a lock pulse and a rearm pulse
will be sent when the TRUNK is closed or if the TRUNK was left
closed.
•
Option 2 (Default: Engine Start/Stop):
The first Ground (-) pulse
