P. 20
Installation
Guide
CT-3460 TW
that the LED is active. If you press
LOCK
and
UNLOCK
once more, the parking lights will
flash 3 times quickly to show that the LED is now disabled.
•
Flashing LED ON:
The LED will flash at all times (being passive or active arming) to
denote that the Starter Kill is active.
•
ACTIVE
Arming: the LED flashes normally.
•
PASSIVE Arming:
the LED will flash, during the countdown, at a faster rate
until the Unit is armed, at which time the flashing rate will slow
down.
•
In Valet Mode
, the LED will be on solid.
•
Flashing LED OFF:
The LED will not flash when the module is armed (passive or
active arming). However, if the module is in Valet Mode, the LED will remain on
solid when the Ignition is “OFF”.
Horn Confirmation
AUX 1
can be programmed to trigger the horn every time the
LOCK
button is pressed, or when the
LOCK
button is pressed twice within 3 seconds. When horn confirmation is activated, panic mode is
enabled. If horn confirmation is disabled, panic mode will not be available.
Safe Start
If this feature is enabled, the user must press the
START/STOP
button 2 times within 3 seconds to
remote-start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing
with the transmitter. To stop the vehicle, the user must press
START/STOP
once. If swap start mode
is selected, to remote-start your vehicle, press the
‘F’
button and then the
LOCK
button. The
Aux 2
output can be activated by pressing the
START/STOP
button.
Idle Mode
Convenience feature:
Idle Mode allows you to keep the engine running and the
doors locked while you stop, for example, at a convenience store or for a short
delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e no Key in the
Ignition Switch) while the engine is running. For example, if you stop for a delivery or at a
convenience store, lock your vehicle and leave it running for the length of a run cycle while you are
away. Idle Mode can be activated through the same routine as that used for Ready Mode; at the
last step, the
TRUNK
button is pressed instead of the other buttons:
1.
Ensure that all the Doors are closed and that the Shifter is in the Neutral position.
2.
With the Engine already running, apply the Parking Brake and release the Brake Pedal.
3.
Make sure to release the Brake Pedal.
4.
Within 20 sec., push
LOCK
,
UNLOCK
or
START/STOP
on the Transmitter.
The parking lights will flash 3 times quickly and remain lit.
5.
Remove the key: the Engine will go on running.
6.
Exit the vehicle and close the Door.
7.
Press the
TRUNK
button until the system is armed (the doors will be locked if remote
door lock is installed).
If the pre-programmed run-time expires or if the user shuts down the engine by remote control, the
vehicle will get in Ready Mode.
Caution:
Do not leave children or pets unattended in a vehicle running in Idle Mode!!!
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
