Configuration Commands
RLXIC-SV
♦
Intelligent Cellular
User Manual
RadioLinx Intelligent Cellular Serial Modem for the Verizon Wireless CDMA Network
ProSoft Technology, Inc.
Page 125 of 146
May 29, 2009
n=2
: Authentication and encryption, equivalent to "authPriv" setting in
SNMPv3. SNMPv3 is required to do authentication and encryption, SNMPv2c
and SNMPv3 authNoPriv transmissions will be silently discarded. Messages
are both authenticated and encrypted to prevent a hacker from viewing its
contents.
*SNMPTRAPDEST=host/[port]
Controls destination for SNMP Trap messages. If port is 0 or host is empty, traps
are disabled. Traps are sent out according to the SNMP security level (that is, if
the security level is 2, traps will be authenticated and encrypted). Currently, the
only trap that can be generated is linkup.
host=IP address
port=TCP port
*SNTP=n
Enables daily SNTP update of the system time.
n=0
: Off
n=1
: On
*SNTPADDR=[d.d.d.d][name]
SNTP Server IP address, or fully-qualified domain name, to use if *SNTP=1. If
blank, time.nist.gov is used.
d.d.d.d=IP address
name=domain name
*TELNETTIMEOUT=n
Telnet port inactivity time out. By default, this value is set to close the AT telnet
connection if no data is received for 2 minutes.
n=minutes
*TPORT=n
Sets or queries the port used for the AT Telnet server. If 0 is specified, the AT
Telnet server will be disabled. The default value is 2332.
n=0
: Disabled.
n=1-65535
Tip:
Many networks have the ports below 1024 blocked. It is recommended to use a higher
numbered port.
*TQUIT
Disconnects the telnet session. Not available in AceManager.
