Pro'sKit PT-5206U, User Manual

Page: 4 / 16

3
Technical Data
Voltage rating: 3.6V
Battery type: 3.6V Li-on / 1.5Ah
Charging voltage: 5V DC (USB)
Chuck size: Ø 2.4mm/3.2mm
Charging time: 2.5~5hr
No-load speed:
10000/20000 rpm
Charging cord: Micro USB cord
Free running time : 55mins
User Guide
Hold the tool tightly. According to the actual needs, we can set two different speeds of
"low (I)-high (II)" by turning the switch. When not in use, toggle the switch to set the
intermediate position (0) and turn off the tool.
1. Changing the Parts
a. Turn the device off and ensure that the rotating part is stopped.
b. Hold the tool firmly, press the spindle lock, and loosen the locking collar.
c.
Remove previous accessory and store safely.
d. Select the appropriate accessory for the job
e. Seat the accessory fully into the collet and tighten the locking collar firmly
2. Warning!
a. Before using the tool, ensure that it is ready and safe to use.
b. Do not use in wet condition and enviroment.
c.
Never use the tool near to flammable gas or liquids.
d. If the tool stops unexpectedly or appears to break down in use, disconnect
from the power supply before handling moving parts.
e. For your protection always wear safety goggles and breathing mask, keep
fingers, hair and clothing clear of moving parts.
f. Do not touch the drill/grinding tip during operation(even if it is in low speed),
because it can cause injury.
3. Charging the Tool
a. Connect the power supply (DC5V 500mA to 2000mA), insert Micro USB into
the machine.
Red light=In charging Green light=Charging completed
b. Charger will automatically stop charging when it is completed. It is ok to leave
tool on charger continually
NOTE!
A battery pack that has been unused for a while or never been charged must be
charged before reuse or first use.
CAUTION! Do not charge battery frequently in quick succession, which may result in
danger for overcharging the battery pack.
4. Operation
a. Toggle switch (0), shutdown status.
b. Turn on the switch (I), rotate speed 10000rpm.
c.
Turn on the switch (II), rotate speed 20000rpm.