1034413B-2/19
Install pads to one set of mounts.
Press a pad into
the smaller bail
(marked “A”).
Press a pad into the
backbone. (You may
need to rotate the pad
to fit correctly.)
Attach small bail to backbone.
Use the upper hinge slot
on the backbone.
BACKBONE
BAIL
Place the mount onto the bar, opening toward the front of the car.
•
Close and compress the mount around the bar.
•
Insert a short hex bolt into the hex opening in the barrel sleeve, and insert into mount.
Bolt threads
MUST
extend
below the
closed bail.
IF THE BOLT DOES NOT EXTEND,
remove the bail, and set the end
into the lower slot.
Always use the short bolt with small bail — and long bolt with large bail.
If the bolt threads still do not
extend below the closed bail:
•
Use the larger bail (marked “B”)
with longer bolt.
•
Repeat step 2 and 3.
Always install
the pad on the
bail for this
fitting process.
Attach the thumb-wheel:
If there is any looseness, or the mounts can slide
on the bar, follow the fitting process again.
Repeat the fitting
process until the factory
bar mount conforms
to the size of your roof
rack bars when the
wheel is tightened.
