1034413B-5/19
Install wheel straps
(if not installed earlier)
Slide the open wheel straps
onto the wheel tray with the
red buttons towards you.
Install tray end caps
Load and Secure your bike — (bike weight limit is 30 lbs.)
Set your bicycle in
the wheel tray with
the hoop lying flat
between the wheels.
NOTE:
The front
wheel of the
bicycle must
rest inside
the hoop.
Raise hoop
and roll bicycle
forward as
jaws meet the
down tube.
In the open position, jaws should clear the bike frame.
The bike carrier can mount above or below most attachments,
such as waterbottles.
To avoid paint wear,
clean contact points
on frame before
tightening Jaws.
Some attachments on the down tube must be removed
if the jaws cannot attach above or below them.
Tighten grey knob
Do not overtighten!
Pull the strap through
wheel spokes on the
front and rear wheels.
Do not let the strap push
against the valve stem.
Close the straps
•
Insert the strap
end behind the
red tab.
•
Tighten the strap
by repeatedly
lifting the grey tab.
Do not overtighten
the strap!
•
If the wheel is still
loose in the tray slide
the strap in the tray
until it rests against
the rim.
•
Tighten again.
UNLOADING BICYCLE:
Unscrew grey
knob and roll
bicyle out of hoop.
Release the strap
by pushing the
grey button.
BEFORE DRIVING AWAY
•
Check the knob.
•
Check both wheel straps.
•
TIGHTEN IF NECESSARY.
Do not
overtighten!
