![background image](http://html.mh-extra.com/html/promise-technology/vtrak-m200f/vtrak-m200f_quick-start-manual_1617265023.webp)
Step 7: Set IP Address with CLI or CLU
23
The current iSCSI Port settings are displayed (above).
To make iSCSI Port settings manually:
1.
Press the arrow keys to highlight DHCP.
2.
Press the spacebar to toggle to Disabled.
3.
Press the arrow keys to highlight IP Address.
4.
Press the backspace key to erase the current IP Address.
5.
Type the new IP Address.
6.
Repeat the previous steps to specify the Subnet Mask, Gateway IP Address
and DNS Server IP Address.
If you do not have a DNS server, skip the DNS Server IP address.
7.
Press Ctrl-A to save these settings and move to the iSCSI Port 2 screen.
8.
Follow the same procedure to make settings for iSCSI Port 2.
9.
Press Ctrl-A to save these settings.
Exit the CLU
1.
Highlight Skip the Step and Finish and press Enter.
2.
Highlight Return to CLI and press Enter.
This completes the Management and iSCSI port setup. Go to “Step 8: Install
iSCSI Initiator on the Host PC” on page 24.