UltraTrak RM4000
6
Figure 3.
UltraTrak Drive Carrier
7. Insert screws through the holes in the Drive Carrier and into the
bottom of the hard drive. Snug each screw. Be careful not to over
tighten.
8. Slide the assembled Drive Carrier back into the UltraTrak and press
the handle forward to lock the Drive Carrier.
9. Repeat steps 2 through 7 until all of your hard drives are installed.
Caution
If you plan to operate your UltraTrak with less than four
hard disk drives, install all four Drive Carriers into the
Chassis, even if they are not holding a drive.
Important
The Drive Carrier Handle must be locked or the disk drive
will not power up.
Handle
Hard Drive
Mounting Holes
(total of 4)
Insert the carrier into
the chassis this way
ATA
Connector
Power Connector
