Quick Start Guide
5
Step 3: Install Hard Drives
Before using, the UltraTrak must first be populated with ATA hard drives.
Be sure to set the jumpers on the new hard drives for
single
or
master
operation. Consult the drive manual for the proper settings.
Figure 2.
UltraTrak Disk Drive Access
Install new hard drives into the UltraTrak by doing the following:
1. Unlock and open the Front Panel Door on the UltraTrak.
2. Pull the Drive Carrier Latch Handle and remove an unused Drive
Carrier (see Figure 2) from the UltraTrak. Begin at the right and
work left.
3. Carefully lay the hard drive into the drive carrier, with the drive’s
connectors facing the carrier’s connectors.
4. Slide the hard drive so the drive’s ATA connector fits into the
carrier’s ATA connector.
5. Attach the Drive Carrier power cable to the hard drive (see Figure
3).
6. Lower the hard drive into the Drive Carrier so that the screw holes
on the bottom line up.
Front Panel
Drive Latch Handle
