Pr
o
Minent
®
Page 10
Mounting and installation
Now, all connecting terminals are freely accessible. At the bottom of the control, there are closed
holes which have to be pried out to feed through the connecting cables.
The 5 feedthroughs of the rear row are meant for PG11 screw fittings.
The 4 feedthroughs of the front row are meant for PG7 screw fittings.
Figure 2: Opening of the control
IMPORTANT
Use pry-out tools to pry out the closed cable feedthroughs at the bottom of the control to
prevent any damage of the board and the threads!
Connection of cables
왘
Pry out closed cable feedthroughs at the bottom of the control
왘
First connect the cables of the rear row: (see Figure 3)
Push PG11 screw fittings (1), thrust washer (2) and gasket (3) from the enclosed
supplementary kit onto the cable, insert into the threaded holes, and tighten fingertight
왘
Then connect the cables of the front row: (see Figure 4)
Pull the PG7 screw fittings (4) over the cable and lock with the locknut (5)
왘
Connect the flexible wires to the terminals according to the electrical connection diagram
왘
Position unused terminals onto the pertinent strips
왘
Close the control
Figure 3: Cable feed rear row
1
PG11 screw fitting
2
Thrust washer
3
Gasket
BA_DS_011_02_07_GB.p65
12.02.2007, 12:03 Uhr
10
