7
Tab
Slot
Downrod
6. Install the ball end of the downrod into the opening
of the mounting bracket. Rotate the downrod until the
tab in the mounting bracket is seated in the slot in the
downrod ball.
WARNING:
The fan and/or downrod should not rotate
in the mounting bracket, if installed correctly. Failure
to align the slot in the downrod ball with the tab on
the mounting bracket may result in fan falling causing
serious injury or death.
Downrod Pin
Downrod Clip
Yoke
Downrod
Set Screw
5. Slide the downrod into the yoke of the motor assembly,
align the holes, then re-install the downrod pin and
downrod clip. Secure with the two set screws and slide
the yoke cover down until it rests on top of the motor
assembly.
Note:
With wiring extending out of the downrod,
measure 8 inches of lead wire and cut the excess wire with
wire cutters (not included). Then strip 1/2” of insulation
from the end of each wire.
WARNING:
Do not cut braided cable.
7
6
5
ASSEMBLY INSTRUCTIONS
Mounting
Bracket
Mounting
Bracket
Receiver
7. Insert the receiver in the mounting bracket with
antenna end first and flat side facing up.
Note:
The receiver rests directly on the downrod.
Summary of Contents for 51484
Page 1: ......