13
SETUP INSTRUCTIONS
The elite monitor needs to know unit cost per kWh charged by your electricity supplier, along with
voltage and alarm settings. The following steps will move through each of these settings.
Press and hold down
mode/set button
for three seconds to enter
the setting mode.
1 – Voltage
Press and hold
mode/set button
for two seconds. Default voltage
is set at 120V. Use
backward
and
forward
buttons to change the
voltage. Press
mode/set button
to save your setting and move
into currency selection setting.
2 - Currency Selection
Select the currency using
backward
and
forward
buttons. Default
currency will be “$”. Push
mode/set button
to confirm and to
move onto tariff selection set up.
3 - Single Tariff Set Up
On release you will see the 1 in the lower right hand corner of
the
monitor. If you are charged one single tariff push
mode/set
button
to confirm.
4 - Electricity Cost
Default cost is set at 0.1$/kWh. Use
backward
and
forward
buttons to change the cost per kWh. Press mode/set button to
save your setting.