51
USER GUIDE //
ELECTRICAL STRETCHER SUPPORT SERIES: PB460/0 - PB460/1 - PB460/2
Review 03/20
06
ELECTRICAL CIRCUIT DIAGRAM
06.3 Hand control operation
BUTTON 1 - Raise stretcher support
BUTTON 3 - Fowler position
BUTTON 5 - Unload position
BUTTON 6 - Load position
BUTTON 4 - Trendelemburg position
BUTTON 2 - Lower stretcher support
Definición de las funciones
Function Button
Membrane
Definition
A
1
By pressing button 1, M1 and M2 will retract synchronously and
the stretcher support will rise. Keep the button pressed until the
desired position is obtained.
2
By pressing button 2, M1 and M2 will extend synchronously and
the stretcher support will lower. Keep the button pressed until
the desired position is obtained.
B
3
By pressing button 3, M1 will retract and M2 will extend, to ob-
tain the Fowler position. Keep the button pressed until the desi-
red position is obtained.
4
By pressing button 4, M1 will extend and M2 will retract, to ob-
tain the Trendelenburg position. Keep the button pressed until
the desired position is obtained.
C
5
By pressing button 5 for 1 second, M1 and M2 will move simul-
taneously to the preset unloading position. The buzzer will beep
when the position is reached.
6
By pressing button 5 for 1 second, M1 and M2 will move simul-
taneously to the preset loading position. The buzzer will beep
when reaching the position.
If you keep the button pressed, M1 and M2 will continue to move
simultaneously up to the upper limit. The buzzer will beep again
when the position is reached.
D
1+3
RESET procedure
By pressing buttons 1 + 3 for 3 seconds all actuators will retract
to 0 mm and then go to the upper limit. To indicate that the ope-
ration has been completed successfully the LED on the contro-
ller will blink 3 times and the buzzer will beep.
E
2+4
Motors to
maximum stroke
By pressing buttons 2 + 4 for 3 seconds all actuators will extend
to their maximum stroke. To indicate that the operation has
been completed successfully the LED on the controller will blink
3 times and the buzzer will beep.
F
-
Stop the movement
of the motors
To stop the movement during C functions, press any button on
the remote or operate one of the load or unload handles of the
stretcher support and all the actuators will stop.
