USER’S MANUAL. TV EXPLORER II/II+
12/2013
Page
35
En
g
lis
h
The
TV EXPLORER II / II+
allows directly changing the tuned channel pertaining
to the active channel plan by means of the horizontal cursors [6]
key. From this
way, once selected the channel-tuning field
[24] and in the
TV
[10] and
MEASUREMENTS
[12] operation modes is possible to check cyclically the entire
active channel list.
NOTE
:
The icon
in the upper corner of the screen indicates that the
equipment is carrying out an internal operation and user must wait to
complete it.
5.10 Acquisition function (DATALOGGER)
The
Datalogger
function allows the user to carry out and store measurements in a
fully automatic way. It can store for each acquisition the measurements made in different
points of the installation.
The measurements made are relevant to the current analogue
or digital channel, in the active channel plan.
To select the
Datalogger
function, activate the
UTILITIES
[22] menu and
select the
RUN DATALOGGER
option. Later, by turning the rotary selector [1] select a
previously stored acquisition or a
NEW DATALOGGER
.
9/38
TEST POINT:
CHANNEL SET:
CANCEL
PINEMALLCTR
PREMISE1
STATION1
FREQ:
CH:
C/N:
POWER:
MER:
CBER:
VBER:
22.7
<52.4
3.5
dB
dBµV
dB
4.7E-2
1.7E-5
MHz
kHz
482.00
-1
22
DVB-T/H. MPEG-2. MEASURING...
16 Sec.
Figure 12.-
DATALOGGER
screen.
During analogue channel measuring process, a percentage counter appears at the
bottom of the screen showing the percentage of channel measurement done. In the case
of digital channels, appears a timer showing time left to finish in seconds. At the top left
corner appears the channel being measured followed by the total amount of channels in
the current channel plan.
