ENG
28
Service settings manual
The basic parameters are listed in groups
P1
- basic settings,
P2
- settings for heating
circuit,
P3
- settings for heat sources.
All additional settings and adjustments of controller performance are carried out by
means of parameters. Three groups of parameters are available.
Basic parameters
Service parameters
Floor drying parameters
CONTROLLER PARAMETERS
BASIC PARAMETERS
SERVICE SETTINGS MANUAL
Only those parameters that are used in the selected hydraulic scheme are
visible. From the selected hydraulic schemes depend also the factory setting
values of parameters.
Parameter index
Current parameter value
Default parameter value
Setting range
Parameter description
The desired parameter change is shown in the example below, for parameter P1.1.
Content of basic parameters is displayed as follows: