3
INVERTER SPECIFICATIONS:
Output Power Continuous: 200W
Low Battery Shut Down: DC 8.5V ± 0.3V
Operating Voltage: DC 11-14.5V
Frequency: 60 Hz ± 3
AC Output Voltage (RMS Meter): 220V ±10%
Efficiency: 85%
Output Wave Form: Filtered Modified Sine Wave
No Load Current Draw: < 0.65A
Low Battery Alarm: DC 10.3V ± 0.3V
Overtemperature Protection: 100°C ±10%
LOCATION OF CONTROLS
1.
Rubberized handle
2.
Digital display
3.
AC charging port
4.
Solar charging port
5.
Two 12V power outlet
6.
3 x 5V 2.1A USB outlet
7.
Inverter/USB power switch
8.
AC power outlet
9.
Front LED light
10.
LED light switch
11.
Charging LED Indicator
III.
CHARGING THE POWERSTATION
NOTE:
Powerstation must be fully charged for 24 hours before first use. Failure to do so may permanently damage battery.
TO READ THE POWER
STATION’S
BATTERY VOLTAGE / INVERTER STATUS
1.
Press the
“ON”
switch button of the power inverter
2.
Press test button to read the Power Inverter/Battery Voltage status
“VAC”
- Output AC
voltage“
“Hz”
- Output AC frequency
“Watt”
- Power consumption of the device
“VDC”
- Battery voltage of power station
3.
Recharge the unit when
“VDC”
reads < 12V
4.
Switch Power inverter to
“OFF”
before recharging the unit.
CAUTION
This unit has a maintenance free, built-in sealed lead acid battery. Although the Promate arrives partially charged from the
factory, it must be fully charged for 24 hours before first use, even if the digital meter indicates
“VDC”
battery voltage >12.8V,
or if the battery is full. This initial charge pre-conditions of the battery are necessary. Failure to follow this procedure may
permanently damage the battery.
