5
•KEEP TOOL DRY, CLEAN, AND
FREE FROM OIL AND GREASE.
Always use a clean cloth when
cleaning.
Never use brake fluids, gasoline,
petroleum-based products, or any
solvents to clean tool
• ALWAYS SUPPORT LONG
WORKPIECES. To minimize risk
of tipping machine, always support
long workpieces.
• BEFORE MAKING A CUT, BE
SURE ALL ADJUSTMENTS ARE
SECURE.
• ALWAYS USE THE VICE CLAMP
to secure the workpiece.
• NEVER TOUCH WHEEL or other
moving parts during use.
• NEVER START THE CUT-OFF
MACHINE WHEN THE WHEEL
IS IN CONTACT WITH THE
WORKPIECE.
• NEVER cut more than one
workpiece at a time. DO NOT
STACK more than one workpiece on
the machine base at a time.
• NEVER PERFORM ANY
OPERATION
“FREEHAND”.
Always secure the workpiece to be
cut in the vice.
• NEVER hand hold a workpiece.
Workpiece will become very hot
while being cut.
• NEVER reach behind, under, or
within three inches of the wheel and
its cutting path with your hands and
fingers for any reason.
• NEVER reach to pick up a
workpiece, a piece of scrap, or
anything else that is in or near the
cutting path of the wheel.
• ALWAYS release the power switch
and allow the wheel to stop rotating
before raising it out of the workpiece.
• DO NOT TURN THE MOTOR
SWITCH ON AND OFF RAPIDLY.
This could cause the wheel to
loosen and could create a hazard.
Should this ever occur, stand clear
and allow the wheel to come to a
complete stop. Disconnect your cut-
off machine from the power supply
and securely retighten the wheel
arbor bolt.
•REPLACEMENT PARTS. All
repairs, whether electrical or
mechanical, should be made at a
PROMAKER
®
Authorized Service
Center.
WARNING
When servicing use only identical
PROMAKER
®
replacement parts.
Use of any other parts may create
a hazard or cause product damage.
• IF ANY PART OF THIS CUT-OFF
MACHINE IS MISSING or should
break, bend, or fail in any way, or
