4
• AVOID ACCIDENTAL STARTING.
Be sure switch is off when plugging in.
• USE RECOMMENDED ACCESSORIES.
The use of improper accessories
may cause risk of injury.
• NEVER STAND ON TOOL. Serious
injury could occur if the tool is tipped
or if the wheel is unintentionally
contacted.
• DO NOT USE DAMAGED
ABRASIVE WHEEL.
• DO NOT USE THE MACHINE
WITHOUT GUARD IN POSITION.
• CHECK DAMAGED PARTS.
Before further use of the tool, a
guard or other part that is damaged
should be carefully checked to
determine that it will operate
properly and perform its intended
function. Check for alignment of
moving parts, binding of moving
parts, breakage of parts, mounting
and any other conditions that may
affect its operation. A guard or
other part that is damaged must be
properly repaired or replaced by
an authorized service center to
avoid risk of personal injury.
• NEVER LEAVE TOOL RUNNING
UNATTENDED.
TURN
THE
POWER OFF. Do not leave tool until
it comes to a complete stop.
• DO NOT REMOVE THE MACHINE’S
WHEEL GUARDS. Never operate
the machine with any guard or cover
removed. Make sure all guards are
operating properly before each use.
• KEEP HANDS AWAY FROM
CUTTING AREA. Keep hands away
from wheel. Do not reach underneath
workor around or under the wheel
while the wheel is rotating. Do not
attempt to remove cut material while
wheel is moving.
WARNING
Wheel coasts after turn off.
• NEVER USE IN AN EXPLOSIVE
ATMOSPHERE. Normal sparking of
the motor could ignite fumes.
• INSPECT TOOL CORDS
PERIODICALLY and if damaged,
have repaired at your nearest
PROMAKER
®
Authorized Service
Center. Stay constantly aware of
cord location and keep it well away
from the rotating wheel.
• USE OUTDOOR EXTENSION
CORDS. When tool is used
outdoors, use only extension cords
with approved ground connection
that are intended for use outdoors
and so marked.
• DO NOT USE TOOL IF SWITCH
DOES NOT TURN IT ON AND OFF.
Have defective switches replaced
by an authorized service center.
