Promac SY-350V, Operating Instructions Manual

Page: 12 / 77

8. Adjusting the machine
BEFORE PERFORMING THE FOLLOWING
OPERATIONS, THE ELECTRIC POWER SUPPLY AND
THE POWER CABLE MUST BE COMPLETELY
DISCONNECTED.
8.1 Disk head
If excessive axial play is found on the hinge, it will be
sufficient to tighten the screws.
Pay attention and avoid making the joint too tight.
8.2 Adjusting the mitering lock lever
The lock lever may require adjustment when the lever is
limited by the machine base and it fail to adequately
secure the miter angle for machine head.
If there is insufficient brakeage of the lock lever:
- Loosen screw (A)
- Support the bushing (B) so that it does not drop in
position.
- Pivot the lever (C) to unlock side to allow more range of
motion.
- Then tighten the screw (A).
8.3 Changing the disk
To change the disk:
Release the mobile guard (A) by removing the hex socket
screw (B).
Rotate the mobile guard (A) back.
Place a block of wood into the vise.
Lower the machine head to rest the cutting disk or saw
blade on the block of wood.
Use a hex wrench to remove the hex socket screw (C),
Rotate the disk in the clockwise direction to loosen it
(because it has a left-handed thread).
Remove the disk or blade (D) and flange (E) from the
head assembly.
Slip off the flange (E) from the disk (D).
Place the flange onto the replacement disk or blade (D).
Continue the replacement of the disk in reverse order of
removal of the disk.
8.4 Cleaning and accessing the coolant system
Pull out the drain hose from the filter (A).
Pull out the coolant tank from the coolant platform in the
stand.
Remove the filter (A) from the tank
Pour out the coolant
Wash out the dirt and debris.
Replace the filter (A).
Fill with coolant solution of 1:10 ratio of coolant to water
Replace the coolant tank in reverse order of removal.
12