12
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is
fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water
run to make sure that the water is clear and free of impurities. If this precaution is not taken,
there is a risk that the water inlet can get blocked and damage the appliance.
Please note that the cold water connection method is the recommended
connection for this appliance.
The water supply to the appliance can also be connected to the house hot water line
(centralized system, heating system),as long as it does not exceed a temperature of 60 C.
In this case, the wash cycle time will be shortened by about 15 minutes and the wash
efficiency slightly reduced.
The connection must be made to the hot water line following the same procedures as those
for the connection to the cold water line.
Note:This dishwasher should be connected using a water pressure of 0.04 - 1.00MPa.
DIMENSIONS(mm)
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent
cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to
facilitate proper installation.
The water drain hose should be mounted at a height of a minimum of 60 cm and a maximum of 100 cm from the floor
level.
If you intend the drain hose from the dishwasher to empty into a sink make sure the sink is empty and the sink plug
hole is not blocked.
Were the dishwasher is going to be permanently plumb in hook the end of the drain hose into a stand pipe specially
installed for the purpose it should have an internal diameter of at least 38 mm (1
in ) thus leaving an air cap
between the hose and pipe and should be designed in such a way that the water level with in it never covers the end
of the hose.
Never attempt to extend the drain hose by adding extra sections.
½
