SUNBAR2000FC
14
Dimmer 2
- Light intensity control is finer at high level and coarse at low levels.
Dimmer 3
- Light intensity control is finer at low and high levels, and coarse to medium levels.
-
Fans Mode
- Select this function to set the fans operation mode
.
Use the arrow buttons to select
Auto
Speed /High Speed
. Press the ENTER button to confirm your choice.
• Press the ENTER button to confirm your choice.
Press the MENU button repeatedly to exit the menu and save changes.
3.13 FIXTURE INFORMATION
To view all the information on the device, proceed as follows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the icon Information, then press the ENTER but-
ton to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, then select one of the following information
and press the ENTER button to display it.
-
Fixture Time
- Through the Time Information function you can display the operating time of the
projector.
-
Temperature
- Through the Temperature function can be displayed the temperature inside the fix-
ture, near the lamp. The temperature can be displayed in degrees Celsius or Fahrenheit.
-
Fans Speed
- Through the Fans Speed function you can show on display the fan speed present near
the lamp. Velocity is expressed in RPM (revolutions per minute).
-
Software Version
- Through Software Version function you can display the currently installed software
version.
• Press the MENU button repeatedly to exit the menu.
3.14 MASTER/SLAVE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
The Slave unit receives data from the Master unit according to the group which the Slave unit was as-
signed to.
For example, if a slave device is set to Receive Part 1, the Master unit Slave unit will send the automated
Chase Part 1; if set to Receive Part 2, the Chase Part 2 Slave units will receive from the Master.
To set the drive as a slave, proceed as follows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the
StandAlone
icon, then press the ENTER button
to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, and select
Master
/
Slave,
and press ENTER to
confirm.
• Press the UP/DOWN button to select the different modes of operation
Master
,
Slave,
and then press the
ENTER button to confirm your choice.
• Press the MENU button repeatedly to exit the menu and save changes.
Select the desired program on the master unit (described in section 3.19).
Use the DMX connectors of the SUNBLAST2000FC and an XLR cable to form a chain of units.
3.15 SEQUENCE
The unit independently runs through its show. Before you send an automatic program you need to set the
drive as Master/Alone:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the
StandAlone
icon, then press the ENTER button
Summary of Contents for Sunbar2000FC
