9
GOBOZOOM
3.5 CONNECTION OF THE DMX LINE
DMX connection employs standard XLR connectors. Use shielded pair-twisted cables with 120Ω imped-
ance and low capacity.
The following diagram shows the connection mode:
DMX - OUTPUT
XLR socket
DMX - INPUT
XLR plug
Pin1 : GND - Shield
Pin2 : - Negative
Pin3 : + Positive
Fig.7
Fig.6 DMX mode
3.4 DMX MODE
To operate the unit via DMX control to the table on pag.11, which shows the functions and values DMX. As
DMX interface, the unit has 3 poles XLR contacts.
•
To set the DMX mode position the DIP-switch [10] to “ON”.
•
Through DIP-switch [1 - 9] you can select different DMX addresss.
ATTENTION
The screened parts of the cable (sleeve) must never be connected to the system’s earth, as this would
cause faulty fixture and controller operation.
Over long runs can be necessary to insert a DMX level matching amplifier.
For those connections the use of balanced microphone cable is not recommended because it cannot
transmit control DMX data reliably.
•
Connect the controller DMX input to the DMX output of the first unit.
•
Connect the DMX output to the DMX input of the following unit. Connect again the output to the input
of the following unit until all the units are connected in chain.
•
When the signal cable has to run longer distance is recommended to insert a DMX termination on the
last unit.
Summary of Contents for GOBOZOOM
Page 1: ...EN IT Manuale Utente User Manual GOBOZOOM GOBOS PROJECTOR POWERFUL 15W LED...
Page 15: ......
Page 31: ......
