Prolights Tribe SMARTBATIP, User Manual, Page: 32 / 40

SMARTBATIP 12
Auto transmit/receive mode
On Master unit:
• Press the MENU button so many times until the display shows S-tr then press the ENTER button.
• Press the UP/DOWN button and select dtAS. Press the ENTER button to confirm.
• Press the ENTER button again to confirm dtAU.
On Slave unit:
• Press the MENU button so many times until the display shows S-tr.
• Press the ENTER button to confirm.
• Press the UP/DOWN button and select drAS.
• Press the ENTER button to confirm.
• Press the ENTER button again to confirm
drAU.
On Master unit:
• Hold the AUTO button.
On Slave unit:
• Hold the AUTO button (always hold AUTO button on Master unit).
• Wait 5 seconds and release the AUTO button on Slave unit.
NOTE - Use any one of the standalone modes for the master unit. Set the slaves to the same DMX modes.
3.11 OPERATION WITH APP “SMARTCOLORS”
Important: WIFIBOX hardware is required to use this app.
WIFIBOX is a new-generation light control system, conceived to obtain an easy and versatile platform for
LED projectors. The signal transmission is managed wired and wireless (through Wi-Fi), both in input and
output, even allowing to control the fixtures through a smartphones applications “Smarcolors”, available
for IOS and Android devices.
Before using the application, check that all devices are properly configured with WIFIBOX. For device’s
configuration refer to the WIFIBOX manual available on “www.musiclights.it”.
Fig.8