Prolights Tribe SMARTBATIP, User Manual, Page: 29 / 40

9 SMARTBATIP
3.5 AUTO SHOW
This fixture has a built-in automatic program. To access this, please see the below instructions:
• Press the button MENU so many times until shows P-- , then press the button ENTER.
• Using UP/DOWN button, select one of the programs P1 - P4 .
• Press the button ENTER to confirm.
• Press the button MENU until
S--
appears on the display.
• Use the button UP/DOWN to select the auto programs speed S001 - S100 (slow-fast).
• Press the button ENTER save the setting.
3.6 STATIC COLOR
This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• Press the button MENU so many times until shows C-- , then press the button ENTER.
• Using UP/DOWN button, select one of the programs C1 - C15.
• Press the button ENTER to confirm.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.7 MANUAL COLOR
This mode allows to combine the colors red, green, blue amber white and purple
(r, g, b, W)
.
• Press the button MENU so many times until the display shows U-- , then press the button ENTER.
• Select the color r, g, b, W through the buttons UP/DOWN.
• Press the button ENTER to confirm.
• Using UP/DOWN button, select the desired color value 000 - 255.
• Press ENTER button to continue to the next color.
• Continue until the desired mix is obtained.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.8 DIMMER
• Enter in Dimmer mode to select specific dimming curve, press the button MENU so many times until
shows dIM , and press the button ENTER to confirm.
• Press the button UP/DOWN to select OFF - dIM1 - dIM2 - dIM3.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.9 OPERATION THROUGH THE IRC CONTROLLER
To control the SMARTBATIP with the infrared remote control:
• Press the button MENU repeatedly until
SET
, then press button ENTER to confirm.
• Using UP/DOWN button to select On or OFF to enable or disable the infrared remote control.
• Press the button ENTER to confirm the chose.
NOTE - Make sure to point the controller directly at the receiver on the product.
Automatic Mode
Automatic Mode will enable you to run the automatic programs on the product.
To turn on Automatic Mode:
1. Press AUTO on the controller.