PROKORD SMART HOME W411-E J300, Manual

Page: 14 / 15

26 27
Only for indoor use. The robot is designed for floor cleaning in a home environment. It cannot be used on other surfaces (such as
a sofa) or in commercial or industrial environments.
Do not use the robot in mid-air areas, such as in a penthouse, open terrace, or a furniture top, without protective fence.
Do not use the robot at a temperature above 40°C or below 0°C or when there are liquids and sticky substances on the floor.
Remove cables from the floor before use to avoid the cables being dragged around or damaged by the robot.
Clear fragile objects from the floor to avoid damaging valuables if the robot gets stuck or runs into them.
Keep the robot away from children and pets.
Keep the main brush and other accessories out of reach of children.
Do not place objects on the robot.
Keep away from the suction inlet when the robot is working.
Do not use the robot to sweep hot objects.
Do not use the robot to clean long-haired carpets or carpets with dark parts. Dark carpets may not be cleaned normally since the
robot may mistake the dark parts for stains.
Prevent the robot from suctioning hard or sharp objects.
Do not move the robot by holding the protective cover of the laser distance sensor and collision bumper. These are fragile parts.
Turn off the robot and charging base during cleaning or maintenance.
Do not wipe any parts of the robot or charging base using a wet cloth or other liquids.
Use the product in accordance with the instructions in this user manual. The user is responsible for any damages and injuries
caused by improper use.
Do not use the mopping function for carpets or furniture tops.
To avoid water damages, make sure to remove the water tank when the machine is being charged or in standby mode.
Safety Information
Usage Limitations
Safety Information
Do not use battery, charging base or charger provided by any third parties.
Do not dismantle, report, or refit the battery or charging base.
Keep the charging base away from heat sources.
Used batteries should be disposed of according to local regulations.
If the power adapter is damaged or broken, please unplug it immediately and replace it through official channels.
The robot must be shut down during transportation. The product should be transported in its original packaging.
If the robot is left unused for long, it should be fully charged and stored in a cool and dry place. Charge the robot at least
every third month to avoid damaging the battery due to excessive discharge.
Battery and Charging
The laser distance sensor of the product complies with the standard for class 1 laser products of IEC60825 and does not
produce dangerous laser radiation.
Laser Safety Information