USE OF THE PROJECTOR
1) CONNECTING TO THE POWER GRID
Connect the device to the electrical grid following normal safety procedures that are valid
for any device operating in low voltage.
The supply voltage must be: 220-240 V, 50-60 Hz and the supply line must be protected
by an e
ffi
cient grounding link and is equipped with a bipolar switch with di
ff
erential
thermal 0.03 A safety.
2) POSITIONING OF THE PROJECTOR
The installation must be carried out by arranging the space in which the device is to be
used in order to be clear from any obstacle. You can tilt the projector by acting on the
screw on the side bracket with the hexagonal key provided.
For special needs, the device can be fixed with an anchor suitable for the material of the
surface on which it needs to be locked. It is necessary to ensure that all the parts
identified for fixing the projector are in a suitable condition to support the projector.
Finally, make sure that the projector has been fixed permanently to the surface.
3) IGNITION OF THE PROJECTOR
-
Open the lid with the appropriate hooks placed sideways on the projector, see Fig. 7.
Fig. 7
9
A
