50
15
34
36
35
37
37
38
FLAT FACE OF
COMPRESSOR
SHAFT
TORQUE:
25 ± 3 IN-LBS
GAP
GAP
CONNECTING
ROD
DIAPHRAGM
OPENING
15
37
DRIVE HUB
DIAPHRAGM
OPENING
Reassembly Instructions
1.
Prep drive hub to ensure it is clean and free from any debris and/
or contaminants. Use of a Scotch Bright pad is permitted.
2.
Apply Loctite
®
620 (item 50) to the outer race of the bearings in
item 34. Ensure no Loctite
®
contacts the sealing surfaces.
3.
Place the connecting rod assembly (item 37) in position as
shown in figure E FIRST. Insert the compressor shaft assembly
(item 34) into the drive hub SECOND.
NOTE:
the order of this
operation is important.
4.
Install the spring washer (item 35) and snap ring (item 36). Ensure
the spring washer sits evenly against the bearing surface, and the
snap ring is properly seated in the groove in the drive hub.
5.
Install set screw into the connecting rod assembly ensuring that it
mates flush to flat face of compressor shaft after tightening. If
positioned correctly, the areas marked “gap” will be equal in size
(see figure E insets).
Copy Part# 206000, Rev. E
Page 4 of 9
Date: 05/2017
© 2010 Marine Canada Acquisition Inc. DBA SEASTAR SOLUTIONS 3831 No. 6 Road, Richmond, B.C. Canada V6V 1P6
Tel: 604.270.6899
Web: www.proheat.com
INSTALLATION INSTRUCTIONS
figure E.
Figure D.
