With some problems, different indica-
tors flash continuously or intermittently
at the same time to show an alarm
code.
Alarm code
Problem
• The start indicator flashes continuously.
• The end indicator flashes 1 time intermittently.
The appliance does not fill with water.
• The start indicator flashes continuously.
• The end indicator flashes 2 times intermittent-
ly.
The appliance does not drain the water.
• The start indicator flashes continuously.
• The end indicator flashes 3 times intermittent-
ly.
The anti-flood device is on.
Warning!
Deactivate the appliance
before you do the checks. Turn the
programme knob until the marker is
aligned with the on/off indicator.
Problem
Possible solution
You cannot activate the appliance.
Make sure that the mains plug is connected to the
mains socket.
Make sure that there is not a damaged fuse in the fuse
box.
The programme does not start.
Make sure that the appliance door is closed.
Press the start button.
The appliance does not fill with water.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
The appliance does not drain the water.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
Close the water tap and contact the Service.
After the checks are completed, activate
the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the
Service.
If other alarm codes appear, contact the
Service.
If the washing and drying results are
not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector to
a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying phase
or with a low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tablets
can be the cause. Try a different brand or
activate the rinse aid dispenser and use
rinse aid together with the combi deter-
gent tablets.
22
progress
