REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual TEKNA ADVANCE 5
FRONT HEIGHT ADJUSTMENT 2
(standard fork and axle)
SERVICE MANUAL
Only for forks with Ø 12 axle hole, it is possible to change the axle
P
with a longer one (usually 25mm longer).
To replace the fork axle, first you need to remove the fork from its support.
Remove the cap and, with a 19 mm tubular box spanner while holding the fork with one hand, screw off the locknut
B
.
Now, hold the axle in its point
A
(16 mm spanner), screw off the locknut
D
and remove the axle.
Insert the new axle and firmly tighten it on the fork.
Similarly, you can change the fork with another of different size.
.
To get access to the nut
D
, it may be necessary to remove the wheel.
If the locknut
D
is too hard to unscrew, warm it with a hot air blower.
When assembling the fork on the support, put the washer
C
and then the locknut
B
. screw the locknut
B
holding the fork. The correct
torque has to zero the vertical play while letting the fork smoothly swivel.
Remember that the front height adjustment can affect the seat inclination, so it is necessary to check and adjust the fork angle
B
C
P
A
D
