REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual TEKNA ADVANCE 40
SERVICE MANUAL
BACKREST HEIGHT
Standard rear frame
Remove the backrest upholstery and slide up the protecting sleeves of the backrest bands along the tube until the fixing bolt/washer/nut
A
is
accessible.
If the bolt is not accessible, remove the mudguard -
see sheet “
mudguard
”
Screw off the bolt/washer/nut
A .
Raise or lower the backrest tubes to the desired height and fix the tube with bolt/washer/nut
A
.
If the minimum height you can reach is not enough, you will need to cut off the lower side of tube.
If the maximum height you can reach is not enough, you will need to replace the tube with a longer one.
Warning
: to guarantee a good stability, between the fixing hole and the lower side of the tube, there should be at least 4 cm. If the tube is
cut, the lower hole will be only a few millimetres front the end of the tube; therefore, you should not use that hole, the next and, sometimes
even the third to fix the backrest height.
To reduce possible play and possible noise, you can put some sticky tape around the inner tube at its bottom and at its fixing point.
m
in
. 4
c
m
A
