REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual TEKNA ADVANCE 29
SERVICE MANUAL
ONE PIECE FLIP-UP PLASTIC FOOTPLATE
ANGLE ADJUSTMENT
Leave the footplate engaged in the using position.
With round tube
: loosen the bolt
A
of both adjustment supports.
With elliptical tube
: loosen the grab screw
A1
and the bolt
A
of both adjustment supports.
Turn the plate frontward or backward.
Once reached the correct inclination, tighten the bolt
A
on the lock side.
Check the footplate engages and disengages easily (you may need to make a minor angle
adjustment working on the plate) and then tighten the bolt
A
of the rotation side
With elliptical tube
: tighten the grab screw
A1
.
POSITIONING
4 positions: internal; 2/3 internal; 2/3 externa (not present in the order form); external
INTERNAL 2/3 INTERNAL 2/3 EXTERNAL EXTERNAL
10 cm
It is possible to change the footplate position in different ways
1) Loosen the angle adjustment bolts
A
and remove the lock side support and the rotation side
support from the tubes and assemble them exchanging their position.
2) Remove the tubes following the instructions of the chapter footplate
distance
and assemble
them again exchanging their position.
Finally, adjust the angle adjustment.
Using either of these two methods, you can turn the footplate position from internal to external
(or vice versa) or from 2/3 internal to 2/3 external (or vice versa).
When reversing the footplate in either these two methods, you change the lock side, too.
Follows next page
A
A
Lock side
A1
A
with elliptical tube
Rotation side
