JOKER EVOLUTION 36
7.0 Accessories
Some accessories require two supports to be mounted on the
wheelchair and may be requested on the order form when
purchasing the wheelchair; they can also be purchased later and
installed by qualified personnel.
The support on the frame
(figure 56) and the support on the rear
axle (figure 57)
, according to the accessory, has to be mounted on
the left and/or right rear sides of the wheelchair and enable the
use of removable swing away armrests, transit wheels and anti-tip
wheels, tipping aids and crutch support.
For the possible combination see table 2.
Table 2 : Possible combinations
Support on frame S1
Supporto on axle S2
RIGHT
LEFT
RIGHT
LEFT
1
Tubular armrest
Tubular armrest
Transit wheel
Transit wheel
2
Tubular armrest
Tubular armrest
Anti tip wheel
Anti tip wheel
7.1 Height
adjustable
removable
swing
away
armrests
The swing away armrests (figure 58) are inserted into the accessory
support “S” with a steel locking system.
Thank to this system, this kind of armrests can be removed or
rotated outwardly as to make moving in and out of the wheelchair
easier.
To adjust the height of the armrest:
Remove (using a 3 mm Allen key and a 8 mm spanner) the
fixing screws “A”.
Raise or lower the armrest by sliding it up or down the support
”B” until the desired height is reached.
After adjusting the height, tighten the screws “A” in the nearest
pre-drilled hole.
To facilitate transfers, it is possible to rotate the armrest by 180° or
simply remove it completely.
Fig. 56 Fig. 57
S2
S1
Fig. 58
