EXELLE 29
With standard rear frame
(figure 47)
Height adjustment: the rear wheel plate “K” c a n b e f i xe d i n
s i x d i f f e r e n t h e i g h t s . Remove the rear wheel (see chapter 5.5
“Quick release rear wheels”). Then, with a 4mm Allen key and a
10mm spanner, remove the bolts “A” and nuts “A
1
”. Move the rear
wheel plate to a higher or lower position given by the pre-drilled
holes every 1.5cm on the frame. Finally tighten all bolts and nuts.
Depth adjustment: six different fixing position are possibile for the
wheel receiver “B”. The rear wheel plate “K” allows the receiver
“B” to be fixed in any of the three holes “F”. tu rn in g th e re a r
wh e e l p la te u p si d e d o wn (1 8 0 °),(see figure 47) it will be
possible to have three other positions.
Remove the rear wheel (see chapter 5.5 “Quick release rear
wheels”). To change depth, remove, with a 22 and 24 spanner, the
receiver “B” with its washer and nut.
Should it be necessary to turn the rear wheel plate up side down,
remove, with 4mm Allen key and 10mm spanner, the bolt “A” and
nuts “A
1
”.
When the desired setting is reached securely fix all bolts and nuts.
With Dynamic rear frame
(figures 48, 49,50)
The Dynamic rear frame is an accessory in this model, therefore it has to be requested at
purchase (and marked in the order form).
Height and depth adjustment:
the rear wheel plate “K” is made of two arms “A” and the two
supports fixed to the frame “S1” e “S2” . These four parts are
fixed to each other with a joint system. The receiver “B” can be
fixed both in the central hole of either one of the two arms “A” (as
in figure 48) , and in either one of the three joints ”T”.
Fig. 47
Fig. 48
13 22 24 26
3 4 5