7. Support Frame Handlebar Installation:
As you begin to mount the
Hand Pulse Handlebar Support Frame (41)
to the
Mainframe (59)
,
insert the
Tension Cable (79)
through the bottom opening in the shaft of the
Hand Pulse
Handlebar Support Frame (41)
and pull it out through the shaft opening located midway up the
support frame. See
Figure G
.
Fully mount the
Hand Pulse Handlebar Support Frame (41)
to the
Mainframe (59)
. After being
mounted, secure the
Hand Pulse Handlebar Support Frame (41)
onto the
Mainframe (59)
with
four
Bolts (47)
, four
Spring Washers (36)
, and four
Washers (24)
. Use the
6mm Allen Wrench
with Phillips Screwdriver
to tighten the bolts until they are firm and secure.
Connect the
Sensor Wire (78)
attached to the
Mainframe (59)
to the
Extension Sensor Wire (10)
coming from the bottom end of the
Hand Pulse Handlebar Support Frame (41)
. Make sure the
connectors “click” when connected. See
Figure A
.
Multi Hex Tool with Phillips
Screwdriver
Tools:
6mm Allen Wrench with
Phillips Screwdriver
ASSEMBLY
18
Figure G
Figure A
(47) Bolt
4PCS
(24) Washer
4PCS
(36) Spring Washer
4PCS
Hardware:
Summary of Contents for 300LS
Page 5: ...LABEL PLACEMENT 3...
Page 7: ...5 OVERVIEW DRAWING...
Page 10: ...HARDWARE TOOLS PACK 8...
