ProForm PFEX01416.1, User Manual

Page: 12 / 40

12
9
131
132
95
81
9. Identify the Right Control (131), which is marked
“Gears.” Connect the wire on the Right Control
to the Right Control Wire (81). Insert the excess
wire into the Handlebar (7).
Tip: Avoid pinching the wires. Attach the
Right Control (131) with a #8 x 1/2" Self-tapping
Screw (95).
Repeat this step for the Left Control (132).
7. Have a second person hold the Handlebar (7)
near the Handlebar Carriage (105).
Locate the wire tie (D) in the right side of the
Handlebar (7). Tie the indicated end of the
wire tie to the Right Control Wire (81), which is
marked with a tag. Then, pull the other end of
the wire tie until the Right Control Wire is routed
through the Handlebar. Then, untie and discard
the wire tie.
Route the Left Control Wire (70) through the
Handlebar (7) in the same way.
8. Tip: Avoid pinching the wires. Hold the
Handlebar (7) on the Handlebar Carriage (105),
and rotate the Handlebar to the desired angle;
make sure that the Handlebar is centered on
the Handlebar Carriage.
Attach the Handlebar (7) with the Handlebar
Clamp (28) and four M6 x 16mm Screws (110);
start all the Screws, and then tighten them.
7
8
7
7
110
70
7
81
D
D
28
105
Avoid pinching
the wires
105
Avoid pinching
the wires
D
81