36
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted.
To adjust the drive belt, first press the power switch
to the off position and unplug the power cord.
Next, use a standard
screwdriver to pry off
the Shield Cover (75)
and the Shield Cover
Cap (118).
See assembly step 15 on page 14. Remove the
Right Leg Outer and Inner Covers (69, 83).
See assembly step 12 on page 12. Remove the
Right Pedal Arm (58) from the Right Upper Body
Leg (60).
Next, remove the M8 x 16mm Screw (95), the Large
Axle Cover (53), and the M8 Washer (not shown) from
the right Crank Arm (20). Then, carefully remove the
Right Pedal Arm (58) and the Right Roller Arm (59)
from the elliptical.
See EXPLODED DRAWING C on page 43.
Identify the Left and Right Shields (73, 74). Remove
the M4 x 19mm Screws (5), the M4 x 25mm Screws
(140), and the M4 x 48mm Screw (107) from the Left
and Right Shields; make sure to note the location of
each size of Screw. Then, remove the Right Shield.
Next, locate and loosen the Idler Screw (89). Tighten
the Belt Adjustment Screw (91) until the Drive Belt
(113) is tight. Then, retighten the Idler Screw.
Reattach the parts that you removed. Then, plug in the
power cord.
75
118
95
58
59
20
53
113
91
89
