PROFILO VS7PT SERIES, Instructions For Use Manual

Page: 16 / 40

䡲
If it is very dirty, the motor protection filter should be
rinsed.
The filter must then be left to dry for at least 24 hours.
䡲
After cleaning, slide the motor protection filter into the
vacuum cleaner and close the dust bag compartment lid.
Replacing the micro-hygiene filter
Figure
䡲
Open the dust bag compartment lid (see Figure 17).
䡲
Release the filter holder by pressing the locking tab in the
direction of the arrow
䡲
Remove the foam filter and micro-hygiene filter.
Insert the new micro-hygiene filter and foam filter into the
filter holder.
䡲
Insert the filter holder into the vacuum cleaner and clip
into place.
Replacing the micro active carbon filter
Figure
䡲
Open the dust bag compartment lid (see Figure 17).
䡲
Release the filter holder by moving the locking lever in
the direction of the arrow.
䡲
Remove the micro active carbon filter.
䡲
Insert the new micro active carbon filter into the vacuum
cleaner and clip into place.
Replacing the HEPA filter
Figure
䡲
Open the dust bag compartment lid (see Figure 17).
䡲
Release the HEPA filter by pressing the locking tab in the
direction of the arrow and remove it from the vacuum
cleaner (see Figure 20).
䡲
Insert the new HEPA filter and clip into place.
If you have used the vacuum cleaner for fine dust particles,
clean the motor protection filter by knocking out the dirt
and, if necessary, replace the micro hygiene filter, active
carbon filter or HEPA filter.
Care
Always switch off the vacuum cleaner and disconnect the
power cord from the mains before cleaning the vacuum
cleaner.
The vacuum cleaner and plastic accessories can be cleaned
with a commercial plastic cleaner.
!
Do not use a scourer, glass-cleaning agent or all-
purpose cleaning product.
Never immerse the vacuum cleaner in water.
The dust compartment can, if necessary, be cleaned with a
second vacuum cleaner or simply wiped with a dry cloth or
dusting brush.
Subject to technical modifications.
22*
21*
20*
you wish to stop vacuuming for a short time.
To do this, slide the catch on the floor tool into the
groove on the back of the vacuum cleaner.
When the work is done
Figure
䡲
Unplug the vacuum cleaner.
䡲
Briefly pull the power cord and release. The cord rewinds
automatically.
Figure
To store or transport the vacuum cleaner, use the storage
aid on the underside of the vacuum cleaner.
Stand the vacuum cleaner up on its end. Slide the catch
on the floor tool into the groove on the underside of the
vacuum cleaner.
Changing the dust bag and filters
Replacing the dust bag
Figure
If the dust bag change indicator is completely yellow
when the floor tool is lifted from the floor and the highest
suction power is selected, the dust bag must be
changed, even though it may not yet be full. In this case
it is essential to change the dust bag due to the type of
material it contains.
First check that the nozzle, suction pipe and flexible hose
are not blocked, as this would also lead to the dust bag
change indicator being triggered.
Figure
Open the lid by moving the locking lever in the direction
of the arrow.
Figure
a)
Seal the dust bag by pulling the sealing strip and then
remove it.
b) Insert a new dust bag into the holder and close the dust
bag compartment lid.
!
Caution: the lid will only close when the dust bag is
inserted.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly by
knocking out the dirt and rinsing.
Figure
䡲
Open the dust bag compartment lid (see Figure 17).
䡲
Pull out the motor protection filter in the direction of the
arrow.
䡲
Clean the motor protection filter by tapping it.
19
18
17
16
15
14
en
*Depending on version
8