ProfiCare PC-FT 3094, Instruction Manual

Page: 69 / 128

69
PC-FT3094 IM new 20.04.21
• ,IWKHWHPSHUDWXUHJRHVDERYHƒ&ƒ)³ ” (high) will appear in the
display. If the temperature goes below ƒ&ƒ) , “ ” (low) will appear in
the display.
Notice:
:KHQWKHVXUURXQGLQJWHPSHUDWXUHLVORZHUWKDQƒ&ƒ) or
KLJKHUWKDQƒ&ƒ) , it’s not allowed to measure as accut-
racy in not assured.
Object Temperature Measurements
• Press the trigger to switch the thermometer on with one beeper. The device per-
forms a brief self test: all elements of the display are shown for approx. 1 second.
Following a successful self test with backlit (Red - Orange - Green).
• Press the “ B / O ” button for “Object temp” for accurate measurements in the range
RIƒ&WRƒ&ƒ)WRƒ)
• Hold the device by its handle and point it toward the surface to be measured.
• Press the trigger to take a temperature reading. The temperature reading appears
in the display.
• Release the trigger and the reading will hold for approximately 15 seconds after
which the thermometer will automatically shut off.
Note: Before shutting off, you can take further measurements.
• If the temperature goes above ƒ&ƒ) , “ ” (high) will appear in the
display.
If the temperature goes below
ƒ&ƒ) , “ ” (low) will appear in the display.
Notice:
• The value under this mode is object temperature instead of core
temperature.
• The defaulted infrared from the real temperature according to different emissivity.
For example, the reading on stainless steel will be obviously lower than the actual
temperature. Not all surfaces can be measured correctly due to the material
HJWUDQVSDUHQWPDWHULDOGLUW\RUUHÀHFWLYHVXUIDFHV'HYLDWLRQVPD\DOVRRFFXU
ZKHQPHDVXULQJOLTXLGV%HFDUHIXOWRDYRLGEXUQVVFDOGV%(&$87,216)25
SCALDING!