20
89. FX TO AUX1 level control
It adjusts the level of the internal effect signal sent to the AUX 1 output.
90. FX TO AUX2 level control
It adjusts the level of the internal effect signal sent to the AUX 2 output.
91. FX TO AUX3 level control
It adjusts the level of the internal effect signal sent to the AUX 3 output.
92. FX TO AUX4 level control
It adjusts the level of the internal effect signal sent to the AUX 4 output.
93-94. TAP button and LED
When “TAP DELAY” effects (p 9, 10, 15) are selected, by pushing at least two times this button it’s possible to set the
desired delay time, according to music rhythm. The TAP LED flashes in sync with the delay time set.
95. FX1/2 SEND level control
It adjusts the master level of FX1/2 signal sent to internal effect. Use it to reduce the level of signal sent to the internal
effect if the PEAK LED is flashing. This control ranges from off to max fully clockwise.
96. PEAK detector
If the peak LED flashes this means that the signal is too high, near to the clipping of the effect input stage. In this case,
reduce the level of the single channel FX1/2 (AUX5/6) send or of the master FX1/2 SEND.
97. MUTE indicator
When the MUTE switch is engaged this LED lights.
98. MUTE button
Engage this switch if you want to mute the signal from the internal effect.
99. 1-2 switch
Engaging this switch you assign the FX output signal to the GROUPS 1-2 bus regulated by the GROUPS 1-2 faders.
100. 3-4 switch
Engaging this switch you assign the FX output signal to the GROUPS 3-4 bus regulated by the GROUPS 3-4 faders.
101. MAIN switch
Engaging this switch you assign the FX output signal to the MAIN MIX bus regulated by the MAIN MIX fader.
102. SOLO indicator
If the SOLO LED lights this means that you have activated the SOLO switch of the internal effect.
103. SOLO switch
This switch allows you to hear the signals of FX output through your headphones or MONITOR outputs and to display
the level on LED meters.
104. FX FADER LEVEL control
It adjusts the level of the internal effect signal sent to the MAIN MIX or GROUP outputs.
105. AUX SEND 5-6 jack output
This jack connector sends out balanced line-level signals made of the sum of the AUX 5 or 6 busses.
106. AUX SEND 1-4 XLR output
This jack connector sends out balanced line-level signals made of the sum AUX 1, 2, 3 or 4 busses, usually for connecting
to the inputs of external effect devices or stage monitor.
107. EQ section HIGH control
This control gives you up to 15dB boost or cut at 12KHz with a “SHELVING” curve shape.
108. EQ section MID control
This control gives you up to 15 dB boost or cut at the frequency determined by the FREQ knob (see FREQ next) with a
"PEAKING" curve shape.
109. EQ section FREQ control
This knob ranges from 100 Hz to 8 kHz and determines the center frequency for the MID EQ. This allows you to zero in
on the precise narrow band of frequencies you want to have affected by the MID EQ.
110. EQ section LOW control
This control gives you up to 15dB boost or cut at 80Hz with a “SHELVING” curve shape.
111. MUTE indicator
When the MUTE switch is engaged this LED lights.
